WAGNER Plast Coat 430, Руководство по эксплуатации

Страница: 51 / 116

51
Plast Coat 430
GB
*GUIFEFGFDUJTOPUDBVTFECZPOFPGUIFBCPWFNFOUJPOFEGBVMUTIBWFUIFEFGFDUFMJNJOBUFECZUIF8"(/&3DVTUPNFSTFSWJDF
MALFUNCTION POSSIBLE CAUSE ELIMINATION
Pressure at the manometer rises
to more than 40 bars.
7JTDPTJUZPGUIFDPBUJOHNBUFSJBMUPP
high.
Mortar hose diameter too small.
Mortar hose is too long.
Coating material “plug” in the mortar
hose. Mortar hose not prerinsed with
cellulose paste.
Dilute the coating material.
Use a mortar hose with a larger diameter.
Use a shorter mortar hose.
Depressurize the mortar hose – set the selector
switch to “R” (reverse).
Pump the coating material back into the con-
tainer.
The mortar hose must be pres-
sureless.
Watch the manometer ––> 0 bar.
Wear safety goggles.
Decouple mortar hose and rinse with water hose.
When the plug has been removed, fill cellulose
paste in the mortar hose. Couple the mortar hose
back on.
.PSUBSTQSBZJOHNBDIJOFEPFT
not pump enough coating ma-
terial.
$POWFZDBQBDJUZTFMFDUFEUPPMPX
Mortar hose diameter too small.
Stator worn.
Texture tip too small.
Set the volume regulator higher.
Use a mortar hose with a larger diameter.
.PVOUBOFXTUBUPSJGOFDFTTBSZBMTPBOFXSPUPS
Attention:
4QSBZPOQVNQTMJEJOHNFBOT
Select a larger texture tip.
Rule of thumb: Granular size x 3 ––> Tip size
Coating material is emitted at
the inspection hole (1).
1
The shaft seal that seals between the
pump unit and the drive unit is worn.
4UPQXPSLJNNFEJBUFMZCFDBVTFPUIFSXJTFDPBU
-
JOHNBUFSJBMNBZFOUFSUIFESJWFBOESFTVMUJOB
defect.
Clean machine and contact Wagner customer
service.
ELIMINATING FAULTS