WABECO D2400, Руководство по эксплуатации

Страница: 9 / 39

9
6. Start-up and Maintenance
6.1 Electronical equipment
The lathes are fitted with a main switch with undervoltage release, i.e. this switch must be
turned on before turning on the reserving switch. The main switch must also be switched on again
following a power failure.
i
All lathes can only be switched on with closed plexiglass bonnet.
When changing the sense of rotation by turning the right-left switch, the switch must remain for 1
sec. on 0-position for the reason that the relay of the potentiometer has enough time to switch.
6.2 Start up
i
Prior to the initial operation, the machine must once more be cleaned with great care
and all lubrication points have to be lubricated with grease. Thoroughly oil the cross
support, lead screws, guiding rods and spindle sleeve.
Check all spindles by hand in order to ensure they run smoothly.
Run in the lathe on the lowest speed. A full load to start with must be avoided.
6.3 Maintenance
The working life is vitally dependent upon appropriate care. The lathe needs to be cleaned after
every turning job.
i
In case the lathe is to be installed in a moist cellar room, all bare parts need to be
oiled after use to avoid corrosion.
All moving parts must constantly lubricated with grease.
In case of backlash inside the bearings or inside the guideways of the slides,
readjust in time to avoid the bearing or the guideways of the slides being destroyed.