WABECO D2400, Руководство по эксплуатации

Страница: 10 / 39

10
6. Start-up and Maintenance
6.4 Lubrication
Prior to every putting into operation all lubricating points of the lathe must be lubricated with grease
for roller bearings of commercial quality.
Both guiding bars have to be greased before every putting into operation. The two dovetail guides
of the cross support, the threaded spindles accessible from below, the feed shaft as well as the
tailstock sleeve have to be greased with lubricating oil every 100 service hours.
When greasing make sure to put the slide of the cross support to its hindmost position while moving
the tailstock sleeve to its foremost position. The tailstock spindle is to be greased via the hollow
bore in the sleeve.
apply grease prior to
every putting into operation
6.5 Initial cleaning of the machine
Prior to the initial operation all bare parts have to be cleaned by applying petroleum or benzine,
because these parts were covered with antirust oil before leaving the factory.