Voxx ELITE911, Руководство по установке

Страница: 3 / 12

3
+12V
Horn
Module ORANGE wire
1. Installation
A. Siren / Horn (ORANGE on 3-Pin Connector)
Make appropriate connections below.
Siren
• Mount bell housing downwards.
• Use at least two (2) screws to secure siren to mounting location.
• Connect siren BLACK wire to module ORANGE wire.
• Connect siren RED wire to a fused +12-volt source.
Horn
Circuit verification -
Negative Systems - Target wire will register ground when horn is pressed.
Positive Systems - Target wire registers voltage when horn is pressed.
Diagram 1
Horn
Wire Relay Diagram 1
Connect to target wire.
Positive Negative
Connection
B. 12V+ Main Feed (RED)
• Connect to vehicle battery or to main 12-volt lead at ignition switch harness.
Circuit Verification - Target wire registers voltage at all times.
C. 12V+ Switched Feed (BLUE on 7-Pin Connector)
• Connect to switched 12-volt lead at ignition switch harness.
Circuit Verification - Target wire registers voltage when ignition key is turned to the
ON position and START position.
D. Ground (BLACK)
• Attach to grounded metal point of vehicle chassis.
Note: When installing multiple components (such as an alarm and remote starter),
ground the units separately.
Fused