Voxx ELITE911, Руководство по установке

Страница: 4 / 12

4
Diagram 2
Door System - Relay Needed
G. Illuminated Entry (VIOLET on 3-Pin Connector) (Y-11 Only)
• Circuit Verification - Target wire is usually the door pin switch wire. Refer to
section F for verification guideline.
• Add a relay and connect as shown below:
H. Trunk / Hatch Release (TAN) (Y-11 Only)
•
Circuit Verification - Refer to Vehicle Wire Color and Location Chart for circuit
type and location, or verify the vehicle wire using the following guideline:
•
Positive Systems - Target wire registers voltage when the trunk / hatch is
opened using the vehicle button.
•
Negative Systems - Target wire registers ground when the trunk / hatch is
opened using the vehicle button.
1. Installation
F. Door Pin Switches (YELLOW or WHITE on 7-Pin Connector)
Connect appropriate module wire to vehicle target wire. (See diagram 2 below.)
Circuit Verification - Refer to Vehicle Wire Color and Location Chart for circuit
type and location, or verify the vehicle wire using the following guideline:
•
Positive Systems - Target wire registers voltage when any door is opened.
•
Negative Systems - Target wire registers ground when any door is opened.
E. Starter Interrupt
• WHITE/RED -Starter Key Side
• WHITE - Starter Motor Side
• Connect to vehicle starter wire at ignition switch harness.
Circuit Verification - Target wire registers voltage only when ignition key is turned
to the START position.
Circuit Verification after starter wire is cut:
• KEY SIDE of starter wire registers voltage when ignition key is turned to
the START position.
• MOTOR SIDE of starter wire registers no voltage.
Trunk Release
Wire Relay Diagram 3
Connect to target wire.
Positive Negative
Connection