VorTek SonoPro S36 Series, Инструкция по эксплуатации

Страница: 91 / 107

Series S36 Instruction Manual Appendix A Specifications
A-1 800120
Appendix A Product Specifications
Accuracy
≤1-inch Line Size: +/- 2% of rate
>1-inch Line Size: +/- 1% of rate
Accuracy is dependent on several variables including pipe characteristics and
transducer mounting configuration. Special calibration can improve accuracy.
Contact factory if needed.
Repeatability
+/- 0.2% of rate typical
Velocity: English Units: +/-.25 ft/sec of reading to +/-30 ft/sec
SI Units: +/- 0.08 m/s of reading to +/- 9.1 m/s
Pipe Sizes
Clamp-On Transducers:
2MHz
– 1/2” (15mm) to 4” (100mm)
1MHz
– 2” (50mm) to 20” (500mm)
0.5MHz
– 12” (300mm) to 200” (5000mm)
Installation conditions can affect transducer selection
Measurement Parameters
Volume Flow, Mass Flow, Density, Temperature, Energy Units
Temperature Range
Standard Temperature -4°F to 248°F (-20°C to 120°C)
Electronics Specifications
Power Requirements
16 to 36 VDC, 333 mA, 8 W max.
100 to 240 VAC, 50-60 Hz, 8 W max.
Display
Display
– 2x16 character LCD with backlight
Output Signals
Output Standard
– 2 analog 4-20mA, 2 alarms, 1 pulse output,
1 scaled f requency
Optional Output
– Energy output with the addition of optional RTD inputs
Fluid Types
Acoustically conductive fluids, including most clean fluids and many
liquids with entrained solids or gas bubbles. Some examples are:
Ref ined Hydrocarbons, Petroleum products, Crude oil, Hydraulic fluids,
Diesel and fuel oils, water, wastewater, Hot and chilled water, Glycol
water solutions, Other liquids.