VorTek SonoPro S36 Series, Инструкция по эксплуатации

Страница: 46 / 107

Series S36 Instruction Manual Chapter 3 Operation
3-7 800120
Display Menu
Password
ENTER
Display
Menu
Cycle Time (sec)
0
ENTER
Run Mode
Number of Digits
2
MF Vf Te De T
Y or N
B A1 A2 Fl Dt E
Y or N
If Cycle Time is set to zero, manual advance is required
Used to set the number of digits displayed after the decimal point
MF = Mass Flow
Vf = Volume Flow
Te = Temperature
De = Density
T = Total
B = Battery Status
A1 = Alarm 1 Status
A2 = Alarm 2 Status
Fl = Fluid
Dt = Date and Time
For each parameter:
Select Yes to view parameter in Run Mode
Select No to hide parameter in Run Mode
Display Smooting
Yes
Display smoothing = Yes or No
* E = Energy *
Energy EMS Meters Only
Use
keys to access menus
Use the Display Menu to set the cycle time for automatic screen sequencing used in the Run
Mode, change the precision of displayed values, smooth the values or enable or disable each
item displayed in the Run Mode screens.
Example for Changing a Run Mode Display Item
The following shows how to remove the temperature screen from the Run Mode screens. Note: all
outputs are disabled while using the Setup Menus.
1. Use  keys to move to the Display Menu.
2. Press  key until Mf Vf Te De T appears.
3. Press
ENTER
to select. Press  key until the cursor is positioned below Te.
4. Press  key until N appears. Press
ENTER
to select.
5. Press the
EXIT
key and then
ENTER
to save changes and return to the Run Mode screen.