VorTek SonoPro S36 Series, Инструкция по эксплуатации

Страница: 47 / 107

Series S36 Instruction Manual Chapter 3 Operation
3-8 800120
Alarms Menu
Password
ENTER
Use
keys to access menus
Alarms
Menu
Relay Alarm 1
More >
ENTER
Run Mode
Relay Alarm 2
More >
Alarm LOG
xx Files (ENTER)
Clear Alarm LOG?
YES or NO
<Measure> units
xxxx
xxxx
Alarm File
Time
Date
(Press EXIT to return
to Alarm LOG)
<Measure>
None
Mass
Volume
Temp 1,2
Density
* Energy
<Measure>
None
Mass
Volume
Temp 1,2
Density
* Energy
<Mode>
None
HIGH Alarm (>)
LOW Alarm (<)
<Mode>
None
HIGH Alarm (>)
LOW Alarm (<)
<Measure> units
-+
*
Energy EM Meters Only
Example for Setting an Alarm
The following shows how to set Relay Alarm 1 to activate if the mass flow rate is greater than 100 lb/hr. You can
check the alarm configuration in the Run Mode by pressing the
 keys until Alarm [1] appears. The lower line
displays the mass flow rate at which the alarm activates. Note: all outputs are disabled while using the Setup
Menus.
First, set the desired units of measurement:
1. Use  keys to move to the Units Menu (see page 3-13).
2. Press

key until Mass Flow Unit appears. Press
ENTER
.
3. Press

key until lb appears in the numerator. Press

key to move the underline cursor to the
denominator. Press the  key until hr appears in the denominator. Press
ENTER
to select.
4. Press  key until Units Menu appears.
Second, set the alarm:
1. Use  keys to move to the Alarms Menu.
2. Press the  key until Relay Alarm 1 appears.
3. Press  key to access Measure selections. Press
ENTER
and use the  key to select Mass. Press
ENTER
.
4. Press

key to select the alarm Mode. Press
ENTER
and use

key to select HIGH Alarm. Press
ENTER
.
5. Press  key to select the value that must be exceeded before the alarm activates. Press
ENTER
and use the
keypad to set 100 or 100.0. Press
ENTER
.
6. Press the
EXIT
key and then
ENTER
to save changes and return to the Run Mode screen. (Alarm changes
are always permanently saved.)