VorTek SonoPro S36 Series, Инструкция по эксплуатации

Страница: 9 / 107

Series S36 Instruction Manual Chapter 1 Introduction
1-2 800120
Note and Safety Information
We use note, caution, and warning statements throughout this book to
draw your attention to important information.
Warning!
Caution! Note
This statement appears with
information that is important to
protect people and equipment
from damage. Pay very close
attention to all warnings that
apply to your application.
This statement appears with
information that is important
for protecting your equipment
and performance. Read and
follow all cautions that apply
to your application.
This statement appears with
a short message to alert you
to an important detail.
Receipt of System Components
When receiving a VorTek ultrasonic flow meter, carefully check the out-
side packing carton for damage incurred in shipment. If the carton is
damaged, notify the local carrier and submit a report to the factory or dis-
tributor. Remove the packing slip and check that all ordered components
are present. Make sure any spare parts or accessories are not discarded
with the packing material. Do not return any equipment to the factory
without first contacting VorTek Customer Service.
Technical Assistance
If you encounter a problem with your flow meter, review the configura-
tion information for each step of the installation, operation and set up pro-
cedures. Verify that your settings and adjustments are consistent with fac-
tory recommendations. Refer to Chapter 7
– Troubleshooting, for specific
information and recommendations.
If the problem persists after following the troubleshooting procedures
outlined in Chapter 7, contact VorTek Instruments, Technical Support at
(888) 386-7835 or (303) 682-9999 between 8:00 a.m. and 5:00 p.m.
MST. When calling Technical Support, have the following information
on hand:
•
the serial number and VorTek order number (all marked on
the label on the inside of the enclosure)
•
the problem you are encountering, and any corrective action
taken
•
application information (fluid, pressure, temperature, and
piping configuration)