VorTek SonoPro S36 Series, Инструкция по эксплуатации

Страница: 23 / 107

Series S36 Instruction Manual Chapter 2 Installation
800120 2-11
6. With the transducer cables connected, apply a thin coat of coupling grease to the
transducers. If the coupling grease that came with your SonoPro ® flow meter unit
runs out, contact VorTek Instruments to order a replacement container.
7. Place the transducers in the left and right mounting bracket of the rail/ fixture
system. Once the rightmost transducer is fitted, move the clamp so that the scribe
line on the transducer is placed at the flow meter’s determined location. Refer to
the green arrow in Figure 2-12 for this locating point. Tighten the set screw com-
pletely. Note: the transducer in the left mounting bracket does not need to be
moved as the scribe line is already aligned with the scale zero.
8. Tighten the worm-drive clamps using a standard screwdriver so the rail fits tight
on the pipe.
9. Tighten the screw with plastic knob on the top of each transducer mounting
clamp so the transducer fits tight on the pipe. Do not overtighten.
Figure 2-12. Spacing Locating Point on Small Rail/Fixture System*
* Note: Scale not shown here. Scale to be included with actual Small Transducer Rail/Fixture