⇒
Fig. 204
Dipped beam
headlights
Side
lights/daytime
running lights
Turn signal
Main beam
headlights
Insert the bulb
holder
③
into
the headlight and
turn it clockwise as
far as it will go.
Insert the bulb
holder
④
into
the headlight and
turn it clockwise as
far as it will go.
Insert the bulb
holder
⑤
into
the headlight and
turn it clockwise as
far as it will go.
Insert the bulb holder
⑥
into the
headlight and turn it
clockwise as far as it
will go.
8.
Fit the rubber
cover
①
.
Fit the rubber
cover
①
.
Fit the rubber cover
②
.
9.
Close the bonnet
⇒
In the engine compartment
.
The illustrations show the left-hand headlight from the rear. The right-hand headlight is a
mirror image of the one shown.
There are various types of headlight, so the position and design of covers, bulbs and bulb
holders may vary from those shown in the illustrations.
It is not possible for customers to change the LEDs in daytime running lights with LED
technology. Go to a qualified workshop.
Changing bulbs in the front bumper
Fig. 205
In the front bumper, right-hand side: remove the fog light.
First read and observe the introductoryinformation and safety warnings
⇒
Introduction
The actions should only be carried out in the specified order:
1.
Observe and follow the instructions on the checklist
⇒
Checklist Information on
changing bulbs
.
2.
Take the wire hook from the tool kit and insert it in the opening in the cover
⇒
Fig. 205
. Pull the cover forwards in the direction of the arrow.
3.
Use the screwdriver from the vehicle tool kit to unscrew the securing screw
⇒
Fig. 205
①
⇒
Vehicle toolkit
.
4.
Pull the headlight out of the bumper towards the outside of the vehicle.
5.
Release the connector and pull it off.
6.
Turn the bulb holder anticlockwise as far as it will go and pull it out to the rear
along with the bulb.
7.
Replace the defective bulb with a new bulb of the same type.
8.
Insert the bulb holder into the headlight and turn it clockwise as far as it will go.
9.
Connect the connector to the bulb holder. The connector should click into place.
10.
Push the headlight from the outside into the openings and insert into the bumper.
11.
Use the screwdriver to tighten the securing bolts
⇒
Fig. 205
①
.
12.
Replace the cover in the bumper
⇒
Fig. 205
.
13.
Stow the wire hook and screwdriver in the vehicle tool kit.
Changing bulbs in the front bumper (R-Line)
• Please ensure that the electrical connection on the headlight housing is positioned
properly in order to prevent damage to the electrical system caused by water entering
the system.
• When removing and refitting the headlight, make sure that the vehicle's paintwork is
not damaged.
NOTICE