73
Fig. 35 – LCR table Data Entering
By completing the LCR data adding table you set one call routing rule.
Prefix list –
select one of the prefixlists from the
“GSM
Parameters – Prefixes”
in the pull-down menu to which
the routing rule should apply. The prefixlist settings are
discussed in Subs. 1.12.
Outgoing interface –
this list is used for selecting of
outgoing interface. All outgoing calls are routed to the
respective interface according to the selected prefixlist.
The routing priority is from top to bottom. Therefore, if
the top parameter (GSM module 1) cannot be used, the
call is routed according to the parameter under the first
one (GSM module 2). Setting of routing according to
Any
group/module
is required if the parameter
GSM
parameters – General – GSM module selection
is set up to
Cyclic
or
Smart
. Use ISDN TE interface to set up routing
of calls to TE port according to prefixes in
Prefixlist
.
Time limitation of use–
sets the time limit for the routing
rule defined in this menu. The time validity
From – To
may include weekends too.
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
