IFU-08, Rev D | Date: November 2019
Page 11 of 39
Using the VistaPoint Menu
The VistaPoint menu is found in the top right-hand corner of the application.
From this menu you can:
•
Start New Patient
– This selection will discharge the previously paired
patient and allow a new patient to be connected.
•
Discharge Patient
– This selection will discharge the current or
previously paired patient.
•
Hide Unused
Devices
– If third-party devices are not being used for this
patient, they can be hidden from the VistaPoint application screen. You
can unhide these devices by selected this option again.
•
About VistaPoint
– This option will list the current version of the
software.
•
Help
– This option will bring up a message window that instructs user to
press the home button for access to instructions.
Using the VitalPatch Menu
The VitalPatch Menu is found within the ECG section of the VistaPoint
application. From this menu you can:
•
Disconnect VitalPatch
– Select this option if a biosensor needs to be
disconnected, but other third-party devices are to remain connected or
you will be applying a new VitalPatch to the same patient.
•
Posture Settings
– Select this option if posture needs to be recalibrated.
•
Body Temperature Settings
– Select this option if Body Temperature
needs to be recalibrated, or to change the temperature units. For more
information on recalibration, see “
Step 5: Recalibrate Body Temperature
•
Flash Patch LED
– The pairing between VistaPoint and the VitalPatch
biosensor can be confirmed by selecting this option. Select
Begin
Flash LED
and watch for the light on the biosensor. It will flash for
several seconds. You may select
Repeat Flash LED
again as needed.
If you do not see the LED flash on the biosensor you want to be
connected to, you may need to disconnect and reconnect by following
the steps in this document.
Figure 11: VistaPoint Menu
Figure 12: VitalPatch Menu
Figure 13: Flash LED