VIOLIN SYSTEMS 7700, Руководство по установке

Страница: 129 / 208

Monitoring 7700 FSP Controllers Using iDRAC
530-0267-00 Rev 02
7700 Flash Storage Platform Installation Guide 7.6.3.x
123
Setting Up DNS and Domain Names in iDRAC
Most alert functions require proper DNS and domain name settings to correctly resolve names to
network IP addresses, and to allow alerts to be correctly formatted for Enterprise hosts. Set up DNS
and domain names in iDRAC by completing the following steps:
1.
Open an HTTPS session using the IP address assigned to the iDRAC interface.
2.
Log in to iDRAC using its login credentials (default login credentials are
admin
and
violin101
).
3.
In the navigation pane, click Overview > iDRAC Settings > Network and scroll down to the
Common Settings pane.
4.
In Static DNS Domain Name , enter a valid DNS domain name.
5.
Navigate to the IPv4 Settings pane, and in Static Preferred DNS Server and Static
Alternate DNS Server , enter valid IP addresses.
6.
At the bottom of the Network page, click Apply to apply all these DNS and domain name
settings.
Setting Up Time Zones and NTP in iDRAC
You should inspect and verify that the time zone and NTP information used by IPMI matches that
information used by other 7700 FSP storage cluster devices.
Set up time zone and NTP information in iDRAC by completing the following:
1.
Open an HTTPS session using the IP address assigned to the iDRAC interface.
2.
Log in to iDRAC using its login credentials (default login credentials are
admin
and
violin101
).
3.
In the navigation pane, click Overview > iDRAC Settings and in the iDRAC Information
page, click Settings .
4.
In the Time Zone and NTP page, verify the Time Zone Value and the NTP Server 1-2-3 and
Enable Network Time Protocol (NTP ) check box values in the Time Zone pane.
5.
Click Apply if you make any changes.
Setting Up SNMP E-mail Alerts in iDRAC
iDRAC provides a means to receive SMTP e-mail platform-based alerts about the 7700 FSP
Controllers in the 7700 FSP storage cluster. Use iDRAC to set these e-mail alerts up in addition to
other existing monitoring methods or if you have no other monitoring methods available. To
configure SNMP e-mail alerts in iDRAC, complete the following:
1.
Open an HTTPS session using the IP address assigned to the iDRAC interface.
2.
Log in to iDRAC using its login credentials (default login credentials are
admin
and
violin101
).
3.
In the navigation pane, click Overview > Server > Alerts , and in the Alerts page navigate to
the Alerts pane, click Enabled , and click Apply .