Termoscanner
48
EN
3 - Temperature Measurement and Face Recognition - Settings
Note:
To set temperature measure via the terminal, please tap System Settings
Temperature Measurement.
3.1 - Temperature Measurement Settings
After the network is connected, go to the web client. Click Config
Temperature Measurement to go to the following interface.
1 - Enable "Temperature Measurement", select Celsius or Fahrenheit temperature as neededand then set the high temperature threshold and the low
temperature threshold. When the body temperature measured is higher or lower than the set value, it will trigger alarms.
2 - Set the alarm holding time.
3 - Set the alarm trigger options.
Trigger Alarm Out
: If enabled, the alarm output device will be triggered when detecting an abnormal temperature.
Trigger Audio Alarm
: If enabled, the system will broadcast the current body temperature status on detecting a human body. No matter whether the
detected body temperature is normal or not, the corresponding voice prompt will be heard. If this item is disabled, the detected body temperature status
will be not broadcasted.
Trigger SD Snap
: If enabled,the system will capture images on detecting an abnormal temperature and save the imageson an SD card.
Trigger SD Recording
: If selected, video will be recorded on an SD card on detecting an abnormal temperature.
Trigger Email
: If “Trigger Email” and “Attach Picture”are checked (email address must be set first in the Email configuration interface), the captured pic
-
tures and triggered event will be sent into those addresses.
Trigger FTP
: If “Trigger FTP”is checked, the captured pictures will be sent into FTP server address. Please refer to FTP configuration chapter for more
details.
4. Click “Save” to save the settings.
3.2 - Face Match Settings
NOTE: To set parameter via the terminal, please tap Touch screen Main Menu
Face Config
The setting steps are as follows.
1. Go to Config
Face
Face Match Config interface.
