Vimar Arke 19493, Инструкция по эксплуатации

Страница: 23 / 38

ENGLISH - 21
- Put the dip-switches 1 and 3 onto the desired position and
leave 2 OFF (the dip-switches must be positioned before
inserting the battery).
- If used, make the connections to the N/C input.
- Prepare the control panel for configuring the detector then
insert the battery into the device; the control panel will
confirm reception of the message. The display will show a
configuration message.
- If the N/C input is used too, in the event of an alarm on
the magnetic contact or on the N/C contact the detector
will transmit a single code; on the control panel it will not
therefore be possible to know whether the alarm has been
detected by the N/C contact or by the magnetic one.
- If the wire N/C contact is used and you want to differentiate
the second alarm, prepare the control panel for configura-
tion (the detector connected to the N/C contact can also be
assigned to a different zone to that of the radio contact) and
then put dip-switch 2 onto ON; the control panel will display
configuration of the device.
Warning:
- Connect the N/C contact sensors as illustrated in the figure
on page 23; to use this contact you need to put dip-
switch 4 onto OFF . Using fast contacts such as those for
roller shutters and/or inertia sensors, put dip-switch 3 onto
ON; in this case the alarm will be signalled if, within 30 s,
there are 6 quick openings of the contact.
- The end-of-alarm function (dip-switch 1 in the ON position),
permits checking the device status on the control panel
(contact open or closed).
9 Volt
6LR61