Vimar Arke 19493, Инструкция по эксплуатации

Страница: 6 / 38

4 - ENGLISH
Operation
The device receives the transmissions of the radio wave signals
emitted by the radiofrequency devices and by the remote control.
• Regular operation: receives the information from the radiofre -
quency devices (tamper alarm, burglar alarm, technical alarm,
low battery). It receives the codes from the remote controls and
sends them to the control panel; in addition it receives informa-
tion from the control panel on the system status and sends it to
the siren and remote controls.
• Configuration: in the phase of adding radio frequency devices it
saves the characteristics of the component that has responded
and communicates some information to the control panel.
• Supervision: this function checks the configured Radio
Frequency devices work properly; If a device does not signal
its presence for a time of 4 h, the interface sends a “no devi-
ce” message to the control panel. To obtain this function the
“Supervision” parameter must be active.
Note : If the intrusion detection alarm system is turned on and a
contact has accidentally been left open (a window for instance),
the system will not turn on and the control panel will display the
alarm message and the zone to which the contact left open
belongs.
If you repeat the process for turning it on, the system will activate
itself as normal even with the contact open.
Indicators
• red LED on steady:
- during configuration and reset;
• red LED blinking:
- due to system in alarm or an attempt at tampering with the
device. The LED keeps on blinking until the alarm that generated
it is deleted or the system is turned on again; therefore it is not
enough to turn off the system to cut off the alarm.
• green LED blinking:
- the system is turned on in partitioned mode;
• green LED on steady:
- the system is turned on not partitioned;