Troubleshooting
12
©2010 Viking Preferred Service
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Oven Components
Symptom
Possible Cause
Corrective Action
Bake, broil, convection fan, oven
lights, and surface burner igniters
inoperable
House breaker or fuse open
Reset breaker or replace fuse
Unit unplugged
Plug in unit
Defective oven wiring (shorted,
open, or burned)
Replace high limit
Defective oven wiring (shorted,
open, or burned)
Repair or replace defective wiring
Bake, broil inoperable - convection
fan, oven lights, and surface burner
igniters operate
Open or shorted RTD (cycle light
fl
ashing)
Replace RTD
Open oven control
Replace oven control
Open direct spark module
Replace direct spark module
Defective oven wiring (shorted,
open, or burned)
Repair or replace defective wiring
LED Error Codes
The LED error codes are displayed on the control
panel using the cycle lights. Refer to the chart below to
determine the type of error that is being displayed.
LED Error Codes
Type of error
Cycle Light
RTD
(Oven Probe)
2
fl
ashes, then 4 seconds OFF
Model Header
3
fl
ashes, then 4 seconds OFF
Thermostat Control Connections
(Part may vary)
Quick Power Disconnect
The DCCG130 range has a quick power disconnect
located behind the kick plate. Use this disconnect
location instead of pulling the range from the installation
and unplugging from the outlet.
1. Remove screws and lift kick plate from keyhole
screws.
2. Disconnect Molex connector to remove power to the
range.
3. Reverse procedure for installation.
Содержание DCCG130
Страница 35: ...2010 Viking Preferred Service 35...
Страница 36: ...36 2010 Viking Preferred Service...