Document: LT0439 Vigilant
MX1-Au
Operator Manual
Issue 1.73
23 October 2018
Page 8-9
The following information is displayed:
Datafile1
: this shows the number of the data file and Active if this
configuration file is being used or Disabled if not being used.
CRC
: this shows two values. The first is the integrity checksum for this
data file, followed by the CRC for the configuration file (the same as
displayed by SmartConfig). The correctness of the integrity
checksum controls a system point,
Database 1 CRC
, which will
produce a fault indication if the checksum is not correct. Note that the
integrity checksum shown on line 2 for each data file will be different
even when both data files are loaded from the same SmartConfig
data file. The second value shows the
“invariant” configuration data
file CRC. This is the same value as calculated and displayed by
SmartConfig using the Show CRC command, so these can be
compared to confirm that the configuration data file in the
MX1
is the
same as that in SmartConfig.
If the same SmartConfig data file is loaded into both data file
locations, the invariant CRC value will be the same for each of the
data files.
Datafile
: the name of the SmartConfig file when it was downloaded
into the
MX1
by SmartConfig.
Written
: the time and date on the PC when the configuration was
last changed before being downloaded. Note that random characters
may appear in the time and date fields when there is no valid datafile.
Menu options are:
ACTIVE
F1 is an Access Level 3 command and will appear only if
Access Level 3 is enabled. It forces this data file to become the
active copy. A confirmation prompt is displayed. Press OK to restart
the system and switch to this data file. If this data file is not valid, the
system will automatically switch back to the other data file.
FILE2
F2 switches to the equivalent status display for the second
data file.
PROGRAM
F3 displays information about the controller firmware.
KEYPAD
F4 displays information about the LCD/keyboard firmware.
From the System Memory Status menu, press
PROGRAM
F3 to show
the status of the controller firmware.
Program Memory |
Version: V1.30 |DATAFILE
CRC: nnnnnnnn Normal |
|KEYPAD
Fig 8-9 – Controller Firmware Display
Viewing
Controller
Firmware
Status
Содержание MX1-Au
Страница 104: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 8 18 THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 118: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 9 14 THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 160: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 11 34 THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 182: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 12 22 THIS PAGE INTENTIONALLY LEFT BLANK...