Vigilant MX1-Au, Руководство оператора

Страница: 15 / 182

Document: LT0439 Vigilant MX1-Au Operator Manual
Issue 1.73 23 October 2018 Page 1-7
OPERATING/POWER (GREEN LED)
This indicator has three states;

on (mains power is on)

flashing (mains power is off or disconnected, panel is running from
battery power)

off (panel is not receiving any power and is not operating).
SYSTEM FAULT
Lights yellow to indicate an internal hardware or software fault.
ALARM DEVICES FLT/DISABLED

Lights yellow to indicate that the alarm devices have been disabled.

Flashes yellow to indicate that there is a fault with one or more alarm
devices or transmission paths (circuits).

Very slow flash off indicates alarm devices are silenced remotely.
Note that if a device in fault has been disabled this will override the fault
indication and the indicator will be on steady.
ALARM ROUTING FLT/DISABLED

Lights yellow to indicate that the alarm routing has been disabled (this
is not usually permitted on most installations).

Flashes yellow to indicate a fault with the alarm routing equipment or
connection (if available).
Note that if an alarm routing fault has been disabled this will override the
fault indication and the indicator will be on steady.
FAULTS
The general FAULTS indicator lights yellow to indicate the presence of
faults in the system. Press the associated key to recall these.
A new fault will be accompanied by the sounding of the fault buzzer
unless this has been muted or disabled.
DISABLES
The general DISABLES indicator lights yellow to indicate the presence of
disabled items in the system. Press the associated key to recall these.
TESTS
The general TESTS indicator lights yellow to indicate the presence of
active tests within the system, for example a zone alarm test. Press the
associated key to recall these.
AIF
The AIF indicator lights to indicate that the MX1 is operating in AIF
“Attended Mode” (see page 2-7).
BUZZER
The internal buzzer pulses to indicate an alarm, and sounds continuously
to indicate the presence of a fault. It is silenced by using the
SILENCE
BUZZER key.
Status
Indicators