Viessmann Vitocal 350-A AWHI 351.A14, Инструкция по установке и обслуживанию

Страница: 129 / 140

129
Parameter Code Factory setting Commission-
ing
Operating status for external changeover 7012 2
Effect of external blocking on pumps/compressor 701A 0
Duration of external changeover 7013 8 h
Effect of external demand on heat pump/heating cir-
cuits 7014 4
Effect of ext. blocking on heat pump/heating circuits 7015 4
Vitocom 100 7017 0
Effect of external blocking on pumps/compressor 701A 0
Common system flow temperature sensor 701B 1
Compressor
Parameter
Code Factory setting Commission-
ing
Enable compressor 5000 1
Evaporator temperature for defrost end 5010 200 (
≙
20 °C
Output compressor stage 5030 Rated heating output ac-
cording to type plate
External heat source
Parameter
Code Factory setting Commission-
ing
Enable external heat source 7B00 0
Priority ext. heat source/instant. heating water heater 7B01 1
Dual mode temperature external heat source 7B02 100 (
≙
10 °C)
Enable external heat source for DHW heating 7B0D 0
DHW
Parameter
Code Factory setting Commission-
ing
Set DHW temperature 6000 500 (
≙
50 °C)
Min. DHW temperature 6005 100 (
≙
10 °C)
Max. DHW temperature 6006 600 (
≙
60 °C)
Hysteresis DHW temperature heat pump 6007 70 (
≙
7 K)
Hysteresis DHW temperature booster heater 6008 100 (
≙
10 K)
Start optimisation for DHW heating 6009 0
Stop optimisation for DHW heating 600A 0
Set DHW temperature 2 600C 600 (
≙
60 °C)
Temperature sensor at bottom of DHW cylinder 600E 0
Enable booster heaters for DHW heating 6014 0
Enable electric heaters for DHW heating 6015 1
Priority DHW heating with combi cylinder 6016 0
Start attempts for DHW after high pressure shutdown 6017 1
Operating mode cylinder primary pump 6020 Do not adjust.
Solar
Parameter
Code Factory setting Commission-
ing
Type solar control unit 7A00 0
Commissioning/service reports
Control parameter report
(cont.)
5692878
Appendix