Viessmann Vitocal 350-A AWHI 351.A14, Инструкция по установке и обслуживанию

Страница: 130 / 140

130
Electric booster heater
Parameter
Code Factory setting Commission-
ing
Enable instantaneous heating water heater 7900 0
Enable instant. heating water heater for central heating 7902 1
Max. output instantaneous heating water heater 7907 3
Output for instant. heating water heater at power-OFF 790A 0
Dual mode temp. instant. heating water heater 790B 100 (
≙
10 °C)
Internal hydraulics
Parameter
Code Factory setting Commission-
ing
Heat pump for drying a building 7300 0
Time program for screed drying 7303 0
Set flow temperature for external demand 730C 500 (
≙
50 °C)
Enable 3-way diverter valve heating/DHW 730D 0
Operating mode secondary pump 7340 Do not adjust.
Heating water buffer cylinder
Parameter
Code Factory setting Commission-
ing
Enable buffer cylinder/low loss header 7200 0
Temp. in operating status fixed value for buffer cyl 7202 500 (
≙
50 °C)
Hysteresis temperature heating buffer cylinder 7203 50 (
≙
5 K)
Max. temperature buffer cylinder 7204 600 (
≙
60 °C)
Temp. limit op. status fixed value for buffer cylinder 7208 100 (
≙
10 °C)
Heating circuit 1
Parameter
Code Factory setting Commission-
ing
Standard room temperature 2000 200 (
≙
20 °C)
Reduced room temperature 2001 160 (
≙
16 °C)
Remote control 2003 0
Heating curve level 2006 0 (
≙
0 K)
Heating curve slope 2007 6 (
≙
0.6)
Influence room temperature hook-up 200A 10
Room temperature hook-up 200B 3
Max. flow temperature heating circuit 200E 400 (
≙
40 °C)
Room temperature in party mode 2022 200 (
≙
20 °C)
Heating circuit 2
Parameter
Code Factory setting Commission-
ing
Standard room temperature 3000 200 (
≙
20 °C)
Reduced room temperature 3001 200 (
≙
20 °C)
Remote control 3003 0
Heating curve level 3006 0 (
≙
0 K)
Heating curve slope 3007 6 (
≙
0.6)
Commissioning/service reports
Control parameter report
(cont.)
5692878
Appendix