Viessmann Vitocal 350-A AWHI 351.A14, Инструкция по установке и обслуживанию

Страница: 62 / 140

62
C
B
A
≈
F H
5 4
3
4 4
3
3/N
3/N
G
K
4
kWh
kWh
3
E
D
X3.7
X3.6
Fig. 59 Diagram excluding fuses and RCD.
A
Heat pump control unit (terminals on the cross
connect PCB)
B
Instantaneous heating water heater (accessory)
C
Compressor (fan is directly coupled to the com-
pressor power supply)
D
Power supply, control unit
E
Main isolator
F
High tariff meter
G
Ripple control receiver (contact open: power-OFF
enabled) with backup fuse
H
Economy tariff meter
K
TNC system feed
Phase monitor (if installed)
■
The phase monitor monitors the compressor power
supply.
■
If the internal tolerance range is exceeded or under-
shot, the phase monitor interrupts the safety chain
via a floating contact. The compressor stops.
■
The phase monitor automatically re-enables the
compressor power supply if the values return to
within the specified tolerance range.
No reset
required.
Note
If the phase monitor has responded, check the power
supply and remove the cause of the fault.
Installation sequence
Power supply
(cont.)
5692878
Installation