Viessmann Vitocal 222-A, Инструкция по установке и обслуживанию

Страница: 132 / 156

132
Buffer cylinder
Parameter
Code Delivered condition Commission-
ing
Maintenance/
service
Enable buffer cylinder/low loss header 7200 0
Temp in operating status fixed value for buf-
fer cyl 7202 500 (
≙
50 °C)
Hysteresis temperature heating buffer cylin-
der 7203 50 (
≙
5 K)
Max. temperature buffer cylinder 7204 600 (
≙
60 °C)
Stop optimisation heating buffer cylinder 7205 0
Temp limit op. status fixed value for buffer
cylinder 7208 500 (
≙
50 °C)
Stop hysteresis, heating water buffer cylin-
der 7209 0 (
≙
0 K)
Operating mode, fixed value only for heat
demand 720A 0
Temp in op. status. fixed value for coolant
buff cyl. 7220 200 (
≙
20 °C)
Stop hysteresis coolant buffer cylinder 7223 20 (
≙
2 K)
Min. temperature coolant buffer cylinder 722A 40 (
≙
4 °C)
Start hysteresis coolant buffer cylinder 722B 50 (
≙
5 °C)
Heating circuit 1
Parameter
Code Factory setting Commission-
ing Maintenance/
service
Standard room temperature 2000 200 (
≙
20 °C)
Reduced room temperature 2001 160 (
≙
16 °C)
Remote control 2003 0
Room temperature control 2005 0
Heating curve level 2006 0 ( ≙ 0 K)
Heating curve slope 2007 6 (
≙
0.6)
Influence room temperature hook-up 200A 10
Room temperature hook-up 200B 0
Max. flow temperature heating circuit 200E 400 (
≙
40 °C)
Runtime mixer heating circ 2015 Do not adjust.
Room temperature in party mode 2022 200 (
≙
20 °C)
Cooling 2030 0
Dew point monitor 2031 1
Min. flow temperature cooling 2033 200 ( ≙ 20 °C)
Influence room temperature hook-up cooling
circuit 2034 0
Min. actual flow temperature cooling 2036 10 (
≙
10 °C)
Hysteresis room temp cooling circuit 2037 10
Cooling curve level 2040 0
Cooling curve slope 2041 12
Commissioning/service reports
Control parameter report
(cont.)
5831412
Appendix