Victoria Arduino Adonis+ 2 Gr, Техническое руководство

Страница: 85 / 136

83
EN
Pressure calibration : -200 - 0 - +200 mbars
( WV UP/DOWN to switch).
Pre brewing : not active - active
( WV UP/DOWN to switch).
Cup warmer : single - single temp. - double temp.
( WV UP/DOWN to switch).
Clock calibration : -300 - 0 - +300 sec/month
( WV UP/DOWN to switch).
Serial connection : active - not active
( WV UP/DOWN to switch).
Least group : 0 - 1 - 2 - 3 (
WV
UP/DOWN to switch).
Least serve : 0 - 1 - 2 - 3 ( WV UP/DOWN to switch).
DIRECT LINKS
In "machine ready" state you can go direct to the settings
below instead of surfing the menu.
SETTING THE TEMPERATURE POINT:
Press ENTER +
V
to go directly to the Setting Point
menu (this will be bars or °C/°F depend on the status
view you were).
WV
press UP or DOWN to move up and down
the working Point.
Press ENTER to confirm and pass to the next step.
MONITORING UNIT (°C/°F - BAR)
The display can also show you the pressure or tempera-
ture status of the boiler; to pass from one to the other,
press the
W key on the display.
In the case of pressure, the reading will be shown in bar,
while for temperature, it will be in degrees Celsius (°C)
or Fahrenheit (°F). The display setting for the tempera-
ture can be chosen from the setpoint setting page. In
fact, when choosing the temperature mode, the setpoint
will be shown in degrees Celsius or Fahrenheit accord-
ing to the chosen measurement.
ON OFF STAND-BY
(ENERGY SAVING MODE)
This allows to rotate into the three working modes/sta-
tuses.
Press RESET for 3 sec to switch on
Æ
off
Æ
stand-
by the machine status.