Victoria Arduino Adonis+ 2 Gr, Техническое руководство

Страница: 67 / 136

65
EN
6.5 STEAM FLOW ADJUSTMENT
Use the lever to increase/reduce the flow of steam
injected into the milk, as illustrated in the following figure.
NOTE
Before using the steam wand, always bleed out any
condensation for at least 2 seconds or according to the
manufacturer’s instructions.
6.6 ADJUSTING THE TURBOCREAM
NOZZLE
(If Fitted)
To increase/reduce the amount of air injected into the
milk from the TurboCream nozzle (and therefore to
increase/reduce the amount of foam in the heated milk)
proceed as illustrated in
Fig. 17 :
①
Loosen the stainless steel tube (1) as illustrated in
Fig. 17.A .
② To increase/reduce the amount of air, tighten (turn-
ing clockwise) or loosen (turning anticlockwise)
the Teflon tube
(2) as illustrated in Fig. 17.B .
③
Tighten the stainless steel tube again.
NOTE
By reducing or increasing the length (tightening or
loosening) the tube/Teflon tube by a few fractions of a
mm/mm, there is a significant difference in the amount
of foam in the heated milk.
Fig. 17
Fig. 17.A
Fig. 17.B
Fig. 16
2
1