Victoria Arduino Adonis+ 2 Gr, Техническое руководство

Страница: 76 / 136

74
EN
To access the automatic cleaning counter press
ENTER .
‡ The long coffee keys , on the machine will
begin to flash; when the group key is pressed, the
display will show the number of wash cycles carried
out. Hold down the
RESET key for 3 seconds to
reset.
ACTIVE UNITS (T3 version only)
‡ It is possible to set both the units actually present
and those to be enabled when the control unit is
switched on. To set the number of active units when
the machine is switched on and to change the ac-
tive units, proceed as follows:
‡ Switch on the function by pressing the ENTER key.
‡ It is possible to activate/deactivate individual units
by pressing the WV keys. Press ENTER to con-
firm and to pass on to the next unit. When the last
unit is confirmed, the function returns to the main
menu.
‡ Pressing the RESET key returns to the main menu
and any changes made will not be saved.
NOTE: To make a change effective, it is necessary to
switch the machine off and then on again, using
the main switch located in the bottom right.
NOTE: From the machine ready state, it is possible to
activate/deactivate the deactivated/activated
units by pressing the
V
key and the button for
the unit in question. This temporary change is
active until the machine is switched off and then
on again from the main switch.
NOTE: If the electronic control unit is replaced, when
the “ACTIVE UNITS” are shown on the display,
it is necessary to press the
long coffee key
for the first and second group to make sure that
in the “ACTIVE GROUPS X” on the display, X
actually corresponds to the number of units in-
stalled on the machine.
It is possible to change the value with the
keys.
For machines with 2 units, the value should be
X=2, for machines with 3 units, the value
should be X=3, for machines with 4 units, the
value should be X=4.
PROGRAM. ON/OFF
‡ The display will read:
‡ By pressing the ENTER , the display will read:
where the ON and OFF values indicate when the
machine will turn on and off.
‡ Press WV to change the day forward and back-
ward.
‡ Press ENTER to vary the programmed starting up
time (the message ON 07:30 will start to flash on
and off).
ON-OFF PROGRAM
MONDAY
ON 07:30 OFF 23.30