Victoria Arduino Adonis+ 2 Gr, Техническое руководство

Страница: 68 / 136

66
EN
6.7 ADJUSTING THE AUTOSTEAM
NOZZLE
(If Fitted)
To increase/reduce the amount of air injected into the
milk from the TurboCream nozzle (and therefore to
increase/reduce the amount of foam in the heated milk)
proceed as illustrated in
Fig. 18 :
①
Loosen the stainless steel tube (1) as illustrated in
Fig. 18.A .
② To increase/reduce the amount of air, tighten (turn-
ing clockwise) or loosen (turning anticlockwise) the
Teflon tube
(2) as illustrated in Fig. 18.B .
③ Tighten the stainless steel tube again.
④
As far as concerns temperature settings, see the
relevant programming section.
NOTE
By reducing or increasing the length (tightening or
loosening) the tube/Teflon tube by a few fractions of a
mm/mm, there is a significant difference in the amount
of foam in the heated milk.
Fig. 18
Fig. 18.A
Fig. 18.B
2
1