USING THE DOLLY TO
TRANSPORT THE TOOL OR
ACCESSORY CASE
Due to the weight of the tool and accessory
cases, a dolly is provided for ease of
transportation .
To install the dolly onto the back of the tool or
accessory case:
1 . Engage the upper bracket of the dolly with the
upper bar on the back of the tool or accessory
case, as shown above .
2 . Push in the button located at the lower
bracket of the dolly (between the wheels) .
Engage this lower bracket with the lower bar on
the back of the tool or accessory case . Release
the button and make sure the dolly is secured to
the case .
3 . Raise the handle to allow for ease of rolling
the case .
NOTICE
•
To prevent the tool or accessory case
from teetering on the dolly and becoming
damaged, remove the dolly before
opening the case. The case should lie flat
on the ground to prevent damage to any
of the components.
•
Remove the dolly by pushing in the
button located at the lower bracket of the
dolly. Disengage the lower bracket from
the lower bar, and lift the dolly up and
away from the back of the case.
TM-PFT510_5
TM-PFT510
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_D