4 . Wrap the Vic-Press ring around the fitting
so that the Vic-Press ring cavity aligns/engages
with the seal pocket bead of the fitting .
NOTE:
The Vic-Press ring can be installed only one
way, with the “pipe side” locator over the pipe .
If the “pipe side” locator is positioned toward
the middle of the fitting, the Vic-Press ring will
not close .
DO NOT ATTEMPT TO REMOVE
THE “PIPE SIDE” LOCATOR FROM THE VIC-
PRESS RING. ALTERATIONS TO ANY TOOL
COMPONENTS MAY RESULT IN IMPROPER
PRODUCT INSTALLATION AND WILL VOID
THE VICTAULIC WARRANTY.
To ease handling, the Vic-Press ring can be
installed onto the fitting prior to inserting the
pipe ends into the fitting, as shown above .
5 . Close the Vic-Press ring by aligning the holes
of the two ends . Push the latching pin through
the Vic-Press ring arm completely, as shown
above .
NOTE:
The Vic-Press ring can be rotated
around the fitting for ease of tool positioning .
TM-PFT510_15
TM-PFT510
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_D
