Vicon RV 4116, Руководство по эксплуатации и обслуживанию

Страница: 88 / 192

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Failure information
2
17-211-1.
fm
ID
M
English
- 82 -
Part 3
Barrel-shaped bale.
The forward movement
path is not correct:
excessive feeding at the
centre.
Modify the path of the
tractor.
see "Instructions about
product pick-up" in
booklet 2
Surface of the bale with
rolled and chopped
product.
The product is too dry.
Pick up the product when
cooler.
Bale density pressure is
too high.
Reduce the set pressure.
see "How to adjust the
solenoid valve for bale
density " in booklet 2
The PTO rotation rate is
too high.
Reduce the PTO rate.
The bale compressed
with twine binding
breaks down.
The product is too dry.
Pick up the product when
cooler.
Perform the binding
operation with the net
binder (if installed).
Bale density pressure is
too high.
Reduce the set pressure.
see "How to adjust the
solenoid valve for bale
density " in booklet 2
The PTO rotation rate is
too high.
Reduce the PTO rate.
Table 1: Product defects
Trouble Cause Cure Reference
Table 2: Operation irregularities of the machine
Trouble Cause Cure Reference
The machine gets
clogged with the
product
Too big or irregular bale.
Correct the windrow
dimension
see "How to prepare the
product windrow" in
booklet 2
The speed of the forward
movement is too high Decrease the speed of the
forward movement.
The path of the forward
movement is not correct. Modify the path of the
tractor.
see "Instructions about
product pick-up" in
booklet 2
The PTO rotation rate is
too low.
Increase the PTO rate.
The baffle plate is not
adjusted in a correct way. Lower the position of the
baffle plate. see "How to adjust the
baffle plate" in booklet 4
The tail gate does not
close correctly.
Product debris between
the fixed part of the
machine and the tail gate.
Remove product debris
from the baling chamber. see "How to clean belt
guide rollers" in booklet 2
The side hooks are not
coupled to gate side
rollers.
After hatch closing wait for
the hooks to close before
releasing the hydraulic
control. Avoid counter-
pressures on the
hydraulic circuit that could
operate the hydraulic
cylinders.