VibroSystM STATE-200, Руководство по установке

Страница: 7 / 32

Copyright © VibroSystM Inc., 2011
7 STATE-200 General Description_Rev. 0
●
2. GENERAL DESCRIPTION OF THE STATE-200 UNIT
The STATE-200 unit is an acquisition extension for the ZOOM Controller for measuring and monitoring slow-
evolving signals. The ZOOM platform and ZOOM Look software plug-in must be installed on the ZOOM
Controller to allow functionalities such as data acquisition, data storage, alarm processing, and notification of
triggered alarm on the ZOOM Controller screen.
The STATE-200 is 3U in size, like other products offered by VibroSystM such as the ZPU-5000 and PCU-
5000. The communication interface between the STATE-200 and ZOOM Controller uses an Ethernet
10/100Mbps standard transmission network. Cat 6 STP network cable must be used. This cable allows
installation of the unit at a distance of up to 100m from its network switch. The STATE-200 and ZOOM
Controller can share a network with other VibroSystM instruments also using Ethernet transmission. Each
STATE-200 Unit has 16 input channels, and several STATE-200 units can be installed on a same network.
Several types of input modules are available, covering most of the parameters used in the surveillance of
rotating machines (see below, Table 1: Summary of Available Modules for the STATE-200). The modularity
of the instrument allows installation of several different types of modules on a single Unit. Measurements
taken through this acquisition unit will be synchronized with measurements taken through other VibroSystM
instruments, thus simplifying the analysis work. We can also use this data to assist in the interpretation of
dynamic measurements (taken with ZPU-5000), or trigger measurements under various operation modes
(conditional measurements).
Table 1: Summary of Available Modules for the STATE-200
Model Module Type
AD2T 0 to 20 mA isolated
AD3
4 - 20 mA
AD3T 4 - 20 mA isolated
AD6 0 to 5 V
DC
AD6T 0 to 5 V
DC
isolated
AD7 0 to +10 V
DC
, or contact closure (switch, relay, or other)
AD9T 0 to 50 mV
DC
isolated
AD10T2 3-wire RTD PT100
Ω
_ isolated / -50° to +350°C (-58° to + 662°F)
AD11 -5 to +5 V
DC
AD11T -5 to +5 V
DC
isolated
AD12 -10 to +10 V
DC
AD12T -10 to +10 V
DC
isolated
AD13T 0 to 100 mV
DC
isolated
AD14T 4-wire RTD CU10
Ω
_ isolated / -55° to +150°C (-67° to + 302°F)
AD15T 28 to 140 V
AC
isolated