VibroSystM STATE-200, Руководство по установке

Страница: 28 / 32

Copyright © VibroSystM Inc., 2011
28 Troubleshooting the STATE-200 Unit_Rev. 0
●
This address is printed at the back of the STATE-200
unit, on the label next to the power input socket.
Once the IP address assigned to the STATE-200 unit has been located in the list of all the addresses assigned
by the DHCP server, use the ZOOM Configuration program to verify the ZOOM configuration. Refer to the
ZOOM 6 Look Plug-in User’s Guide .
5.2.2 Configuration Troubleshooting
In the following cases, the STATE-200 unit is connected to the network and is recognized by the ZOOM Look
service, but a problem is detected at the level of a sensor.
5.2.2.1 Disconnected sensor
If the ZOOM Look service shows the status associated to a sensor, along with the message Signal out
of configured range , the problem is a disconnected sensor.