VibroSystM STATE-200, Руководство по установке

Страница: 13 / 32

Copyright © VibroSystM Inc., 2011
13 STATE-200 Installation and Field Wiring_Rev. 0
●
3. INSTALLATION OF THE STATE-200 UNIT
Although it is normally delivered as part of a complete system, already installed and pre-cabled in a new rack
or cabinet, STATE-200 Units can also be ordered separately, as an addition to an existing installation.
3.1 Preliminary considerations for installation in a 19” rack or cabinet
The following guidelines will help you plan your equipment rack configuration:
•
Allow sufficient clearance around the rack or cabinet for maintenance.
•
Enclosed racks must have adequate ventilation, as each component generates heat. An enclosed
rack should have enough ventilation and air circulation with help of fans and exhaust at adequate
locations to keep enclosed rack pressure.
•
When mounting a unit in an enclosed rack, make sure that the unit’s frame will not block the intake or
exhaust ports.
•
Baffles can help to isolate exhaust air from intake air, which also helps to draw cooling air through the
unit. The best placement of the baffles depends on the airflow patterns in the rack.
•
Cabling must be kept away from sources of electrical noise, power lines and fluorescent lighting
fixtures.
•
The unit must be kept away from sources of electrically conductive dust, as well as water or moisture.
•
Heat generated by equipment near the bottom of the rack can be drawn upward into the intake ports
of the equipment above. When mounted in an enclosed 19” rack or cabinet, it is suggested to leave
at a space of at least 3 1/2” (2U) above each component for ventilation.
•
Side support angles are needed for the installation of the unit.
3.2 Required tools and supplies
•
wire cutters
•
wire strippers
•
set of screwdrivers
•
removable connector extractor
•
pre-assembled ethernet patch cables, or tools and supplies (cable and connectors) for field assembly
•
cable for main power input
•
ground wire
•
input/output signal cables
•
mounting brackets to support the STATE-200 unit
•
cage nuts and screws