Vibration Research VR9500, Руководство по оборудованию

Страница: 11 / 32

7
support@vibrationresearch.com
Connection
Connecting the Device to a Power Supply
CAUTION : This product must be reliably earthed and installed in accordance
with the prevailing electrical wiring regulations and safety standards.
·
Connect the standard AC power cable to the AC connector on the back panel.
·
Connect the power cable to a grounded AC outlet. When used in a control
system, all grounds must be common. This is most easily accomplished by
connecting the power cable to the amplifier's controller outlet. No operator
settings are required for voltage configuration.
·
After connecting the device to a power source, confirm that the device is
connected and operating correctly by examining the LEDs on the front panel.
·
The standard AC power cable is the primary disconnecting device. Position
the equipment so that it is easy to disconnect the AC power cord.
100/1000BASE-T CABLE REQUIREMENTS
All category 5 UTP cables used for 100BASE-TX connections also operate with
1000BASE-T provided that all four wire pairs are connected. However, an
enhanced category 5e cable or newer is recommended for all critical
connections or new cable installations. The category 5e or newer specification
includes test parameters that are only recommended for category 5 and comply
with the IEEE 802.3ab standards.
The VR9500 supports auto-detection of straight through and crossed cables on
all switching 10/100/1000BASE-T ports. The automatic correction of errors in
cable selection makes the distinction between a straight through cable and a
crossover cable irrelevant.