Viavi AVX-10K, Руководство по эксплуатации

Страница: 108 / 147

AVX-10K Operation
Rev. 002 2022-08-25
22135254 VIAVI Page 106 of 139
Setting Definition
Preset (MHz) Will toggle between 108.05, 117.95 and 108.00. The paired TX
Frequency, Channel and Mode values will change accordingly.
VOR (MHz) When in Manual Frequency Entry mode, allows setting a value
between 108.00 and 135.05. The paired TX Frequency, Channel and
Mode will change accordingly.
TX FREQ (MHz) When in Manual Frequency Entry mode, allows setting a value
between 962 and 1213 MHz. Paired VOR Frequency and Channel
will change accordingly.
Channel When in Manual Frequency Entry mode, allows setting a value
between 1 and 126. Paired VOR Frequency, TX Frequency will
change accordingly.
Mode When in Manual Frequency Entry mode, toggles between X and Y.
Paired VOR Frequency and TX Frequency will change accordingly.
Range (nm) Enter a value between 0 and 450 nautical miles.
Range Rate (kts) Enter a value between 0 and 6500 knots.
Range Direction Toggles between IN and OUT.
Reply (%) Enter a value between 0 and 100 percent reply.
Echo Toggles between ON and OFF.
Identification Toggles between OFF, TONE and IDENT.
RF Level (dBm) Enter a value between -67.0 and -2.0 dBm
Up / Down Arrows Raises or Lowers the RF Level based on the Step value
Step Toggles RF Level step values between 0.1, 1.0 and 10.0 increments
6.3.2. Run DME Application
Once your setup and configuration values are entered, press the RUN key. Once the test set starts
receiving the DME pulse pairs from the UUT, the values shown in green below will be displayed. Press
the Pause Rate softkey to stop simulated travel. Press the Save Profile button if you wish to save the
received information.