Vertiv NetSure 502NGFB Series, Руководство по установке

Страница: 58 / 86

Vertiv
| NetSure 502NGFB Installation Manual (Section 6009) | Rev. Z 58
NOTE!
Repeatedly press the “ESC” key to return in reverse order level by level from any submenu until
the Main Menu appears.
Procedure
1. To Select a Sub-Menu:
Press the UP and DOWN keys to highlight the desired sub-menu. Press the ENT key to enter the
selected sub-menu.
2. To Select a User:
To select a User, use the UP and DOWN keys to move the cursor to the Select User field. Press ENT.
Use the UP and DOWN keys to select a User previously programmed into the NCU. Press ENT to select
the User. Note that only Users programmed into the NCU are shown. Users are programmed via the
Web Interface. The default User is admin.
3. To Enter a Password:
If a password screen opens, a password must be entered to allow the User to make adjustments. To
enter a password, use the UP and DOWN keys to move the cursor to the Enter Password field. Press
ENT. Use the UP and DOWN keys to choose a character. Press ENT to accept and move to the next
character. Continue this process until all characters are entered. Press ENT again to accept the
password. The default password is 640275.
4. To Change a Parameter:
Press the UP and DOWN keys to move up and down the list of parameters. Press ENT to select the
parameter. Press the UP and DOWN keys to change the parameter. Press ENT to make the change.
Press ESC to cancel the change.
Checking System Status
Procedure
1. Observe the status of the indicators located on the Rectifier Modules and NCU. If the system is
operating normally, the status of these is as shown in
Table 5 .
Table 5:
Status and Alarm Indicators
Component Indicator Normal State
Rectifier
Modules
Power
(Green)
On
Protection
(Yellow)
Off
Alarm
(Red)
Off
NCU
Status
(Green)
On
Minor
(Yellow)
Off
Critical or Major
Alarm (Red)
Off