Vertiv NetSure 502NGFB Series, Руководство по установке

Страница: 12 / 86

Vertiv
| NetSure 502NGFB Installation Manual (Section 6009) | Rev. Z 12
Making Electrical Connections
 Relay Rack Frame Grounding Connection Made
 Power/Distribution Shelf Frame Grounding Connection Made
 AC Input and AC Input Equipment Grounding Connections Made
 External Interface Connections Made
 Digital Inputs
 Relay Outputs
 Temperature Probes
 Load Connections Made
 CO Ground Connection Made
 Battery Connections Made
 Batteries Installed and Connected in an optional Battery Tray (if furnished)
 Optional External Battery Disconnect Unit Connections Made
 Ethernet Connection Made (if required)
Installing Rectifier Modules
 Rectifier Modules Installed
Initially Starting the System
 System Started, Configured, and Checked
INSTALLING THE SYSTEM
General Requirements
•
This product is intended only for installation in a Restricted Access Location on or above a non-
combustible surface.
•
This product must be located in a Controlled Environment with access to Crafts persons only.
•
This product is intended for installation in Network Telecommunication Facilities (CO, vault, hut, or other
environmentally controlled electronic equipment enclosure).
•
This product is intended to be connected to the common bonding network in a Network
Telecommunication Facility (CO, vault, hut, or other environmentally controlled electronic equipment
enclosure).
•
The installer should be familiar with the installation requirements and techniques to be used in securing
the relay rack(s) to the floor.
•
Typical industry standards recommend minimum aisle space clearance of 2'6" for the front of the relay
rack(s) and 2' for the rear of the relay rack(s).