FT-2000
Operating Manual
Vertex Standard Co., Ltd.
76
[RX] switch “OFF” (LED Off)
[TX] switch “OFF” (LED Off)
2. Press and hold in the SPLIT switch for two seconds to engage the Quick Split
feature, and apply a frequency 5 kHz above the Main (VFO-A) frequency to the
Sub (VFO-B) frequency register. Press and hold in the SPLIT switch for two
seconds to increment the Main (VFO-A) frequency to +5 kHz.
The VFO configuration will then be:
MAIN (VFO-A)
[RX] switch “ON” (LED glows Green)
[TX] switch “OFF” (LED Off)
SUB (VFO-B)
[RX] switch “OFF” (LED Off)
[TX] switch “ON” (LED glows Red)
Quick Points:
The operating mode applied to the Sub (VFO-B) register will be the same as that in
use on the Main (VFO-A) register.
The offset of the Sub (VFO-B) from the Main VFO (VFO-A) is programmed via the
Menu, and is set to +5 kHz at the factory. Other offsets may be selected, however,
using the following procedure:
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu item “031 gene Q SPLIT.”
3. Rotate the [SUB VFO-B] knob to select the desired offset.
The available selections are
-
20kHz ~ +20kHz (factory default: +5 kHz).
4. When you have completed all adjustments, press and hold in the [MENU] button
for two seconds to save the new setting and exit to normal operation. If you only
press the [MENU] button momentarily to exit, any changes you performed will not
be stored.
CW Mode Operation
The powerful CW operating capabilities of the FT-2000 include operation using both an
electronic keyer paddle and a “straight key” or emulation thereof, as is provided by a
computer-based keying device.
Setup for Straight Key (and Straight Key emulation) Operation
