FT-2000
Operating Manual
Vertex Standard Co., Ltd.
110
Default Setting: StP1
StP1:
Activates the µ-TUNE system in the Auto mode using “FINE” steps of the
µ-TUNE knob (1 step/click) on the 14 MHz and lower amateur bands on the
Main band (VFO-A).
StP-2: Activates the µ-TUNE system in the Auto mode using “COARSE” steps of the
µ-TUNE knob (2 steps/click) on the 7 MHz and lower amateur bands. On the
10/14 MHz bands, “FINE” µ-TUNE knob steps will be used (1 step/click).
OFF:
Disables the µ-TUNE system. Activates the VRF feature on the 14 MHz and
lower amateur bands on the main band (VFO-A).
Advice: If the optional RF µ-Tuning Unit (xxxx) is not connected, this adjustment has
no effect.
035 GEnE SNB LVL
Function: Adjusts the Sub band (VFO-B) receiver’s IF Noise Blanker level, when the
Noise Blanker is engaged.
Available Values: nAin(MAIN)/0~100
Default Setting: 50
When this menu is set to “nAin(MAIN),” you may adjust the Noise Blanker level using
the front panel’s [NB] knob.
036 GEnE SUB FIL
Function: Select the Sub band (VFO-B) receiver’s CW narrow filter.
Available Values: non/300/500
Default Setting: non
037 GEnE MIC SCN
Function: Enables/disables scanning access via the microphone’s [UP]/[DWN] keys.
Available Values: On/OFF
Default Setting: On
038 GEnE SCN RSM
Function: Selects the Scan Resume mode.
Available Values: CAr/5SEc
Default Setting: 5SEc
CAr:
The scanner will hold until the signal disappears, then will resume after one
second.