Vermeer 504 PRO, Руководство оператора и по техническому обслуживанию

Страница: 113 / 153

504PRO_604PRO_o-m2_00
-
504/604 PRO Baler Operation Instructions 10-1
10 OPERATION INSTRUCTIONS
10.1 Start Baling
You can start baling when the baler is prepared according to the previous paragraphs:
•
Net or twine is inserted
•
Baler is adjusted to the field
•
Knives are set
• You know how to drive
• Baler settings are made
• Hydraulic shutoff valve of the tailgate and the valve of the pick-up are open
1. On the Home page on the controller, push the button to activate the pick-up.
2. Switch on the PTO shaft in the nominal speed that is indicated on the gearbox.
3. Set the double acting valve in the tractor to "float".
4. Drive rapidly at nominal speed (hand throttle) and according to the drive instructions.
5. When the bale size indicator (see table on page 5-8) indicates that the bale is at the target size, you must stop the tractor.
6. Wait until the bale is wrapped.
•
If automatic bale wrapping is active, wrapping starts automatically.
• If manual bale wrapping is active, you must push the button to start the wrapping.
7. Eject the bale (see page 10-2).
NOTICE
You can always stop the tractor and start the wrapping process even if the bale is not yet at the target size but bigger
than 35.4 inch (90 cm), just push the button.
This is useful when almost all bales on the field are made and if the last bale would become too large or too small. See
options below.
https://tractormanualz.com