VENCO VC 416, Руководство пользователя

Страница: 21 / 52

DATE SECTION
SUPERSEDES
TITLE
VC416-620 UNIVSL S/F
H200
04-01-14A
01-15-13
MOUNTING INSTRCTNS
520941
VENCO VENTURO INDUSTRIES LLC
CINCINNATI, OHIO
®
Refer to drawing 416266 (VC416), 516203 (VC516), 520602 (VC520), or 620104 (VC620) (preceding pages).
A. Position hoist into the front half of the sub-frame by inserting the two lower pivot angles into the lower pivot tube on
the scissors, and then positioning that assembly inside front half of sub-frame. The two holes on each lower pivot
angle should match up with a set of holes on sub-frame mounting brace. The front hole set on sub-frame corresponds
to a dump angle of 45°, and the rear to 50°. See DWG. 520938 for sub-frame features.
NOTE: Position scissor support cross-member for 50° or 45° dump angle accordingly.
B. Fasten lower pivot angles to sub-frame using two [2] 1/2" x 1 1/2" hex head cap screws, lock washers, nuts, and four
[4] flat washers (both sides). See DWG. 520608 Figure 4a.
C. Position hoist with sub-frame front section onto truck frame.
NOTE: Refer to DWG. 520938 universal sub-frame features (section 100) for positioning the hydraulic power unit
cross-member.
D. Place rear section of sub-frame onto truck frame.
NOTE: A distance of less than 38" should be maintained between centers of rear hinge and rear axle. If this distance
exceeds 38", additional reinforcement of truck frame may be necessary.
E. Trim off any truck frame that extends beyond the rear hinge.
F. Fasten rear half of sub-frame to truck by welding the two shear plates (REF. P/N 520932) to rear hinge angle of
sub-frame, drilling corresponding holes through truck frame, and using two [2] 1/2" x 1 1/2" hex head cap screws, lock
washers, nuts, and four [4] flat washers (both sides).
G. Install the sub-frame extensions (if required) using the provided hardware.
H. After attaching the two halves, place mounting angles under the lower pivot angles and against truck frame. Clamp
securely in place. Drill through frame, and install mounting angle with two [2] 1/2" x 1 1/2" hex head cap screws, lock
washers, nuts, and four [4] flat washers (both sides). See figure 5.
NOTE: Do not weld mounting angles to truck frame. This may void the truck's warranty.
I. Weld each end of lower pivot angle to its mounting angle as shown on DWG. 520608, figure 4b. Note the welding
symbols. Do not weld to truck frame.
HOIST MOUNTING INST. - VC416-620 UNIVERSAL S/F