DATE
SECTION
SUPERSEDES
TITLE
VC416/516
H200
03-26-14C
02-24-05A
MOUNTING INSTRCTNS
416747
VENCO VENTURO INDUSTRIES LLC
CINCINNATI, OHIO
®
Position the body longitudinals (long beams) onto the truck frame / sub-frame.
NOTE: At least 2" clearance between the cab and closest point on the truck body is required.
Place the rear hinge brackets in the vertical position (DWG 416290 Figure 2). Weld and/or bolt the brackets to the
longitudinals. If bolted, mark and drill each bracket four [4] places (17/32" holes) and secure the brackets to the
longitudinals using eight [8] 1/2"-13 x 1-1/2" Grade 8 hex head cap screws, eight [8] 1/2" lock washers, and eight [8]
1/2"-13 hex nuts. See installation DWG 662861 for more information regarding the mounting of the rear hinge
brackets to the body.
Refer to DWG 520093 on the following page . Make sure that the dump body longitudinals are resting flush on the top of
the lifting angles. Weld the top of both lifting angles (the vertical 'leg') to the top flanges of the body longitudinals - a
reinforcement plate may be required to fill the space between the lifting angles and body longitudinals. Weld all
around the lifting angles, body longitudinals, and reinforcement plates (if applicable). Be sure that your installation
follows the method shown on the following page (DWG 520093).
ATTACHING REAR HINGE & UPPER PIVOTS TO BODY
!
Step 'L' (above) is a critical installation procedure that
must be carefully followed to ensure a successful
hoist installation. Deviation from the suggested
installation method may result in damage to the hoist.
C A U T I O N
Содержание VC 416
