VENCO VC 416, Руководство пользователя

Страница: 18 / 52

DATE SECTION
SUPERSEDES
TITLE
VC416/516
H200
03-26-14C
03-01-12B
MOUNTING INSTRCTNS
416291
VENCO VENTURO INDUSTRIES LLC
CINCINNATI, OHIO
®
D. Locate the hoist on the truck frame, making sure to center and square the hoist to the truck frame. The
VC-416/516 hoist is designed to rest on the truck frame as shown in Fig.3. A section of the hoist extends
below the truck fram level, thus the hoist may have to be moved slightly forward or backward to avoid frame
crossmembers. The distance between the rear hinge assembly center and hoist dimension. Table "A", figure
1 refers to dump angles associated with the "M" dimension.
E. After the hoist is positioned, place a mounting angle (Fig. 3) under each of the lower pivots and against the
truck frame. Clamp securely in place. Drill through the mtg. angle and frame (17/32") and fasten mounting
angle with two (2) 1-1/2" hex head grade 8 bolts, lock washers and hex nuts (both sides).
Caution
The hoist lower pivot assy. must sit flush on the truck frame. If rivet head interference is
encountered, use a filler block or countersink clearance holes in the bottom of the lower pivot assy. Do
not weld hoist mounting angle to truck frames. This may void the truck warranty.
F. With the hoist lower pivot assys. clamed to the mounting angles (3-1/2x3-1/2x5/16-10" lg.), weld the lower
pivot assy. to the mounting angles. Position and secure the filler strips (wood or steel) to the truck frame (see
fig. 3) The VC416/516 hoist requires at least 5-3/4" clearance above the truck frame.
Figure 3 Mounting Angle/Lower Pivot Assembly
HOIST MOUNTING INSTRUCTIONS (NON S/F)