Vela CineCast 2000-0422, Инструкция по установке и эксплуатации

Страница: 43 / 196

Chapter 1 — Getting Started 29
Software Installation
Installing Under Windows 2000
Just follow these steps to upgrade to version 2.6, remembering that a number of
reboots may be required during the installation process. Do not remove the
CD-ROM disc from the drive until you've completed the final step.
Note: Do not install any new hardware at this time.
If CineCast decoder system software is currently installed, first uninstall the soft-
ware from the Control Panel. See “Uninstalling CineCast Software,” page 37.
1. Install Windows 2000 Service Pack 2, if it is not already installed on your
system. You can download this service pack from the Internet, or you can install
it from the CD-ROM. To use the CD-ROM, follow these steps:
• From the Autorun screen (Figure 1-1), select “Explore This CD.”
• From the “Explore This CD” screen (Figure 1-2), double-click on the
System folder.
• Double-click on the “Win2k Service Pack” folder.
• Double-click on the w2ksp2.exe file.
• The application will extract files, then ask you to read a license agreement.
After reading the agreement, check the “Accept License Agreement” check-
box as well as the “Backup Files Required to Uninstall” checkbox.
• Click Install.
• Click Next, OK, or Finished to all of the screens that follow.
• If you are asked to reboot, allow the system to restart before continuing.
2. The Autorun screen should appear after the reboot. If it does not, run
setup.exe from the CD-ROM or click Start > Run.
After installing Windows 2000 Service Pack 2, if necessary, follow the instruc-
tions below to install hardware drivers. after installing any Vela hardware.
Remember that a number of reboots may be required during the install process.
Hardware Driver Installation — Windows 2000
Before installing CineCast release 2.6 system software, and after installing the
Windows 2000 Service Pack 2, follow these directions to install the hardware
drivers:
1. Shut down Windows, power off the system, and install the new hardware.
2. After reassembling the machine, power up any external decoders, such as the
Quad or Quad Pro, then power up the host PC.
3. If the “Add New Hardware Wizard” appears, click Cancel.