Vega SHLM MI4, Руководство по эксплуатации, Страница: 54 / 72

54 48642-US-150527
8. Continue inserting the cable until the detector indicates that the proper
sensing of the radioactive source has been achieved and that correct
elevation of the source carrier exists.
9. Use the 1/8" hex key to tighten both set screws in the detent plug tightly
against the insert cable.
10. Repeat steps five (5) through nine (9) for each cable.
6.2 Cable Insertion
One (1) pair of all purpose, high grip gloves is recommended to complete the
insertion of the cable.
1.
Pull the shutter outward until it locks into the detent.
2. Return to the actuator cabinet and open the door.
3. Unhook a cable from a cable latch making note of the cable identification.
4. Grab the cable with one hand and push the cable downward and into the flex
conduit, while using the other hand to grab the full cable bundle and rotate it
Tightening the set screw against the cable, "locks-in" the position of
the source carrier, and permits source carrier retraction and re-
insertion back to the same elevation within the well.
The actuator cabinet door is hinged at the bottom and opens
from the top. You must be prepared for the weight of the door
and avoid injury to your body if it falls open.
You may remove the hinge pins from the actuator cabinet
door hinge in situations where the required 30
"
in front of the
cabinet to lower the door is not available. Remember, you
must be prepared for the weight of the door and avoid injury
to your body.
!
NOTE
!
WARNING
!
WARNING