Vega SHLM MI4, Руководство по эксплуатации, Страница: 27 / 72

48642-US-150527 27
4 Operation
4.1 General
Measurement accuracy is highly influenced by the proper installation of the
equipment. This section contains the guidelines for optimizing performance
through proper installation. Also refer to the application sizing sheet and any
installation drawings VEGA provided at the time of the order.
4.2 Unpack the Equipment
Make sure you read and understand all the instructions and safety guidelines in
the Installation and Operation Guide before you unpack, install or operate the
equipment. The instructions in this guide are written for qualified and trained
personnel.
When you unpack your equipment, make sure you follow the steps below.
1.
Unpack the unit in a clean, dry area.
2. Visually inspect the source holder for damage.
3. Check the entire shipment for damage during shipment or storage.
Before you begin installing the SHLM MI cable, it is important to
make certain during the installation that the flex conduit from the
actuator cabinet to the source holder, was connected with as few
bends and with as short a distance as possible.
You must be familiar with radiation safety practices in accordance
with your U.S. Agreement State, the U.S. Nuclear Regulatory
Commission, or other local nuclear and international regulatory
agencies before unpacking the source holder.
Do not sit the source holder on the source carrier cover during
unpacking. The source carrier cover cannot hold the weight of the
source holder.
!
NOTE
!
CAUTION
!
CAUTION