Vega SHLM MI4, Руководство по эксплуатации, Страница: 52 / 72

52 48642-US-150527
5. Locate cable “T” that was extended from the actuator cabinet.
6. To keep the source carrier from rotating during the connection process, insert
a Phillips head screwdriver through the provided hole in the source carrier.
7. Thread the swivel fitting onto the source carrier until the threaded end of the
carrier seats against the bottom of the fitting.
8. Use the Phillips head screwdriver and a 7/16
"
wrench to tighten the swivel
fitting firmly onto the source carrier.
9. Thread the jam nut down against the swivel fitting.
10. Use (2) 7/16
"
wrenches to tighten the jam nut firmly against the swivel fitting
firmly.
11. Follow the steps described above for all cables in the actuator cabinet.
Attaching Source Carrier Cover
The process for attaching the source carrier cover to the source holder is best
performed with two (2) people since actions at both the source holder and
actuator cabinet need to happen simultaneously.
At the Source Holder
1. Installer #1 should hold the source carrier cover and make sure that the
orientation of the cover is such that the cables are in-line with their assigned
source carriers.
2. Installer #1 should now be prepared to move the source carrier cover toward
the source holder as Installer #2 winds the necessary length of each of the
cables back into the cabinet.
The cable will have a swivel fitting on the end that will permit it to be
threaded onto the source carrier “T”.
The process for connecting cable “T” to the source carrier is
complete.
!
NOTE
!
NOTE