a devastation of the buffer --positive slippage .
If parameter “Elastic buf” is setting in “Off”, measurement of parameters and CLSLIP- not
making.
Calibration mode
At a choice of the menu Calibration mode opens the menu shown on figure
5.29
.
The calibration mode calibrates the internal clock generator against a precision clock and the same applies to the
sync port. Note: This step is not recommended.
Warranty and software
Warranty Period:
The warranty period for hardware, software and firmware are one (1) years from the date of
shipment to the customer.
Hardware Coverage:
VeEX Inc warrants hardware products against defects in materials and workmanship.
During the warranty period, VeEX will, at its sole discretion, either
z
Repair the products
z
Replace the hardware which prove to be defective
provided that the products that the customer elects to replace is returned to VeEX Inc by the customer along with
proof of purchase within thirty (30) days of the request by the customer, freight prepaid.
Software Coverage:
VeEX Inc warrants software and firmware materials against defects in materials and
workmanship. During the warranty period, VeEX will, at its sole discretion, either
z
Repair the products
z
Replace the software and/or firmware which prove to be defective
provided that the products that the customer elects to replace is returned to VeEX Inc by the customer along with
proof of purchase within thirty (30) days of the request by the customer, freight prepaid.
Additionally, during the warranty period, VeEX Inc will provide, without charge to the customer, all fixes, patches
and enhancements to the purchased software, firmware and software options. VeEX Inc does not warrant that all
software or firmware defects will be corrected. New enhancements attached to a software option require the
option to be purchased (at the time of order or the time of upgrade) in order to benefit from such enhancements.
Figure 5.29:
“Calibration mode” submenu
Page 29 of 30
TX50e e-Manual D07-00-009 REVA00
