•
Green– test pattern detected.
•
Red– loss of test sequence synchronization at the moment.
•
Yellow– since reset, loss of pattern synchronization signal has been registered.
Any of described LED indicators (except the SIG indicator); will not lit if a corresponding event is not analyzed.
Keyboard description
z
Enter :
This button provides following actions:
1.
When navigating through menus, press this button to enter a highlighted menu.
2.
When setting up parameters values, press the button to change current value or to move to a
submenu parameter selection. If the button performs data input function then use button to move to
previous menu.
z
Escape
: Press to move one menu up or to cancel a set value in the data input mode.
z
Main menu
: Use this button to move to the Main menu.
z
Functional buttons: F1, F2, F3, and F4.
z
A button: To view information on the current hardware and software version.
z
B button: Not implemented in the current release.
z
Cursor buttons: To navigate up, down, left, and right.
z
Others menu
: (Figure
3.2
) To reset LEDs, adjust LEDs’ brightness, Backlight, Contrast, and
Keyboard beep.
z
Power On/Off: To switch the test set on/off press the button and hold it for 1-2 seconds.
Specifications of the analyzer's components
Power supply unit
Provides TX50e analyzer power from the mains and the test set built-in rechargeable battery.
Input: 100 - 240 V AC @ 50 - 60 Hz.
Output: 9V DC @0.8A.
USB cable
The USB cable provides the connection of the test set to a PC. Description of the cable's connector pins is shown
Figure 3.2:
Others Menu
Page 11 of 30
TX50e e-Manual D07-00-009 REVA00
